Dukane Data Video Recorder 8412 - Manual (Page 55)

53
English
Appendices
The projector stops responding to all controls
 If possible, turn off the projector, then unplug the power cord and
wait at least 60 seconds before reconnecting power.
 Check that “Keypad Lock” is not activated by trying to control the
projector with the remote control.
Lamp burns out or makes a popping sound
 When the lamp reaches its end of life, it will burn out and may
make a loud popping sound. If this happens, the projector will not
turn on until the lamp module has been replaced. To replace the
lamp, follow the procedures in the “Replacing the Lamp” section on
pages 55-56.
LED lighting message
Steady light 
No light 
Message
POWER/STAND-
BY LED
Temp-LED Lamp-LED
(Green/Amber) (Red) (Red)
Standby State
(Input power cord)
Amber
Power on (Warming)
Flashing
Green
Lamp lighting Green
Power off (Cooling)
Flashing
Green
Error (Over Temp.)
Flashing
Amber
Error (Fan fail)
Flashing
Amber
Flashing
Error (Lamp fail)
Flashing
Amber
＊ POWER/STANDBY LED be ON when OSD appears, be OFF when OSD disappears.