HP Velotechnik Streamer - Manual (Page 2)

Assembly
1. Attach the quickmount fix a below front boom b. The edge protection strip prevents your frame from
scratches and adapts to the tube shape. Make sure that the quickmount fix is ahead enough to let the
tube h pass the bottom bracket without touching.
2. Pull two hose clips c through the quickmount fix's a slots and around the front boom tube. The worm-
threads should be inside the quickmount fix.
3. Tie up the hose clips and remove unnecessary black plastic tube.
4. The rearward support has to be fixed on the frame's main tube right behind the front boom clamp.
Make sure there is velcro (soft side) stuck on the bracket e for frame protection.
5. Attach bracket e on the main tube and tie up hose clip f. Cut away unnecessary black plastic tube
here as well.
6. Slide the forward elliptical bow h (width ca. 50cm/19", plastic plug at tube's end) into the quickmount
fix and slide the rearward elliptical bow k (width ca. 52cm/20") into tube d. Make sure not to inter-
change the bows as this will lead to improper fit of the STREAMER window.
7. Now you may fit the STREAMER onto its supports using the velcro straps.
8. The STREAMER's height in the knee area is adjusted via telescopic unit d. Loosening or fastening
the knurled nut i causes the rearward elliptical bow k to be movable or fastened.
9. Foot clearance is adjusted via quickmount fix a and support h. After opening the quick release you
may change length and angle.
10. Mount the headlight to the longer end of the bracket g. Slide the cover tube m on the headlight. The
front end of the cover tube can be cut according to the shape of the STREAMER to avoid reflections.
The front light should be asjusted as close as possible to the inner side of your STREAMER. The
bracket is mounted under the the quick release of the forward elliptical bow h. When taking off the
STREAMER, also disassemble the bracket and clamp it with the quick release of the quickmount fix
a. Put the surplus wire into the hole of the quickmount fix.
Please notice while adjusting:
 The
STREAMER's lower edge should be 5cm/2" below bottom bracket axle.
 Your knees must just not touch the fairing, but you should try to install it as low as possible, to get a
good view on the road.

Legs' freedom of motion must be guaranteed.
 Your STREAMER should exceed the front of your recumbent as little as possible in order to keep
your vehicle's length low.
STHPRBR
m
g
STHPRSH