Dell HARMAN/KARDO HK-595 - Manual (Page 4)

Usage
Back to Contents Page
Using the speaker system: Harman/Kardon HK-595 Speaker System
Mode Button • Restoring Default Settings • FX Control • Diagnostics
Mode Button
The Harman/Kardon HK-595 speaker system allows for adjustment of five modes. An LED will
illuminate to indicate which of the tone or effects control features has been selected. Pushing the mode
button provides access to these five modes by toggling the system between the modes in this order:
●
Center
●
Bass
●
Volume
●
Treble
●
Surround
Once a mode has been selected, the control can be adjusted as described in the F/X control section.
After a few seconds, the active mode will default back to the volume control mode. This control will be
adjusted most, thus for convenience you will not be required to toggle through the modes in order to
select, then adjust the volume.
The Harman/Kardon HK-595 will remember the settings when waking up from a power down. The
system will store settings so that when the speaker is turned back on, the system will restore the last
set of control settings.
Restoring Default Settings
The default mode settings are permanently stored in your speaker system. Pushing and holding the
mode button continuously for three seconds will automatically restore the default system mode settings.
F/X Control
The Tone and effects level control sets the level for the selected tone or effects feature. A ring of seven
LED’s around the control indicate the setting of the selected active tone or effects control feature.
A rotary encoder is used for this control. This rotary encoder is free spinning; that is, it can be turned
infinitely in one or the other direction. However, full range on this control only requires 360 degrees or
file:///D|/hk595/Usage.htm (1 of 3)11/16/2004 3:47:17 AM