Hypertherm SensorOHC - Manual (Page 8)

4 Sensor OHC Operation and Set Up Guide
Description and Features
System Features*
Compatible Motors DC shunt 24VDC, 2 Amps to 6 Amps ( customer supplied )
Max Power Output 150W
Control Range Linear 0.1” (2.5mm ) to 1.0” (25mm)
Motor Output Full “H” bridge PWM with current sensing
Accuracy .01” (.25mm )**
Operator controls Easy to use control set point knob and easy read indicators
Calibration Easy access calibration pot on front Panel
Measuring Technology Capacitive Ring with Coax Cable
Dimensions 8.50” (216mm ) W x 4.21” (107mm) D x 4.02” (102mm) H
Inputs/ Outputs 3 outputs and 6 inputs optically isolated on “D” connectors
Weight 2.4 lbs
Operating Environment 0 to 50C; 95% relative humidity (non-condensing)
Power 24VAC +/- 10% 50/60 Hz
*Information subject to change without notice.
** Dependent on customer supplied lifter mechanics
SENSOR™ OHC - Oxy Height Control is an advanced automated height control system for
oxy fuel shape cutting applications. This product utilizes advanced capacitive sensing and
microprocessor technology to automatically detect the plate and adjust torch position to a
desired set point during oxy fuel cutting operations. This reduces operator input, improves
accuracy and increases productivity.
Features
¾ Sensor OHC can be used with any CNC
¾ Easy setup & operation
¾ Both manual & automatic operation modes
¾ Microprocessor control for increased sensitivity and control
¾ High positioning speeds possible with up to 6 amps continuous current and linear
adjustment over full range
¾ Built-in diagnostic and fault detection features
¾ Auto retract on plate contact
¾ Optional second height set point input for preheat or pierce
¾ Indicator lights for operation including:
⇒ Power On
⇒ Upper Limit Switch
⇒ Lower Limit Switch
Options
¾ Five Cable Lengths from 19.7” (500mm) to 59” (1500mm)
¾ Adapter cables allowing direct replacement for existing AR-300/100W Levilator Clearance
Controls
⇒ In Position Indicator
⇒ Attention / Error indicator