Hypertherm HT400 Air Injected Water Muffler System - Manual (Page 13)

INSTALLATION
Page 2-2 Air Injected Water Muffler System
Instruction Manual
UPON RECEIPT
1. Remove the Air Injected Water Muffler System and save the carton. The carton
is reusable and provides an impact-resistant box for transporting or storing the
system and parts. The carton should contain one of the following systems:
034126 Water Muffler System 230/460V, 3 PH, 60 Hz w/Hoses
034127 Water Muffler System 230/460V, 3 PH, 60 Hz w/o Hoses
034128 Water Muffler System 380/415V, 3 PH, 60 Hz w/Hoses
034129 Water Muffler System 380/415V, 3 PH, 60 Hz w/o Hoses
034130 Water Muffler System 575V, 3 PH, 60 Hz w/Hoses
034131 Water Muffler System 575V, 3 PH, 60 Hz w/o Hoses
Refer to Parts List, Section 4 , for a list of components which make up the sys-
tems listed above.
2. Verify that all components are present. Alert your distributor if any parts are
missing.
3. Inspect the water muffler components for any physical damage that may have
occurred during shipping. If there is evidence of damage, see the
Damage
Claims section below.
Before operating the water muffler system, read the Safety and Operation sections of
this manual.
DAMAGE CLAIMS
Claims for damage during shipment
- If any of the components were damaged
during shipment, you must file a claim with the carrier. Hypertherm will furnish you
with a bill of lading upon request. Call Customer Service at 1-800-643-0030.