Ordering information, Ordering procedure – Hypertherm HD3070 w/Manual Gas User Manual
Page 16
HD3070 with Manual Gas Console
Product Configuration Manual
2-5
4
ORDERING PROCEDURE
Ordering Information
The figure below represents an HD3070 plasma system with manual gas console mounted in a robotic environment.
A complete robotic system is also represented in block diagram form on page 2-7. See pages 2-20 and 2-21 for
representations of an HD3070 plasma system with manual gas console mounted on an X-Y cutting table.
Notes:
• Block diagrams are offered to clarify connection points and do not necessarily reflect relative sizes or
distances between components.
• If the cutting system has a power track for cabling and hosing, be certain to see the Specifications
section to check hose, cable and connector diameters.
Figure 2-2
HD3070 System in Robotic Environment
1
HD3070 Power Supply, Manual
2
HD3070 Manual Gas Console
3
Remote High Frequency (RHF) Console
4
Leads Between Power Supply and RHF Console
5
Work Cable Between Power Supply and Work Table
6
Leads Between Power Supply and Manual Gas Console
7
PAC186 Torch (not shown)
8
Quick Disconnect Assembly - Straight (not shown)
9
10 Inch Torch Mounting Sleeve (not shown)
10
PAC184 Torch
11
Quick Disconnect Assembly - 45°
12
8 Inch Torch Mounting Sleeve
12a 10 Inch Strain Relief
13a Shielded Leads Between RHF Console and Torch (with Blow Down
Check Valve & Hose)
13b Shielded Leads Between RHF Console and Torch (without Blow Down
Check Valve)
14a Off-Valve Assembly (with Blow Down Solenoid Valve)
14b Off-Valve Assembly (without Blow Down Solenoid Valve)
15
48 Inch Shield Gas Hose Between Off-Valve Assy and Torch
16
48 Inch Plasma Gas Hose Between Off-Valve Assy and Torch
17
Leads Between Gas Console and Off-Valve Assy
18
Control Cable Between Power Supply and Cutting Machine Interface
19
Current Setpoint Cable Between Power Supply and Cutting Machine
Interface or Between Power Supply and RCC
20
Timer-Counter Cable Between Power Supply and Cutting Machine
Interface or Between Power Supply and Timer-Counter
21
Remote Current Control (RCC)
22
Timer-Counter
12
11
10
22
21
17
5
18
19
20
1
2
4
3
13
6
15 16
14
a
12