beautypg.com

Specifications – Dixon 8950-598 User Manual

Page 11

background image

Page 11

SPECIFICATIONS

Models ZTR 4423 & ZTR 4426

CHASSIS:

Twin 12 gauge side frames and 7 gauge transmission and engine base plate.

BODY:

All body parts are made of high density polyethylene. Dent and corrosion

resistant. Front body contains access panel for battery service.

MOWER DECK:

13 GA stamped steel construction.

(3) blades combine for a 42" cut width.

Cut height approximately 1" to 4" via 7 position lift handle.

BLADE DRIVE:

Electric clutch.

TRANSMISSION:

Each rear wheel is independently driven by chain and sprockets through a

mechanical friction drive.

ENGINE:

Model 4423:

15HP Vanguard Briggs & Stratton, 4-Cycle, Single Cylinder, Overhead

Valve, Air-Cooled, Gasoline, Vertical Shaft With Cast Iron Cylinder Sleeve,

Pressure Lubricated with oil filter.

Model 4426:

16HP Kohler Command 16, 4-Cycle, Single Cylinder, Overhead Valve, Air-

Cooled, Gasoline, Pressure Lubricated, With Oil Filter, Vertical Shaft,

Aluminum Head and Block with Cast-Iron Cylinder Liner.

STARTING SYSTEM:

Electric by key switch operation with safety interlock blade drive.

TIRES:

Front

11 X 4.00 X 5 ribbed tread.

Rear

18 X 9.50 X 8 Turf Trac RS

RECOMMENDED

TIRE PRESSURE:

Front

16-21 lbs.

Rear

8-14 lbs.

CAPACITIES:

Fuel

2.7 gallons total.

Engine

Briggs & Stratton - 1.50 quarts oil.

Kohler - 2 quarts oil with filter.

DIMENSIONS:

Width

47" outside rear wheel measurement.

Height

42" to top edge of seat.

Length

72" hitch tab to front bumper.

Weight

520 lbs.

NOTE:

Additional information provided in service instructions under the individual component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE