beautypg.com

Dodge 2004 Ram Pickup 1500 User Manual

Page 251

background image

Improper alignment will not cause vehicle vibration.
Vibration may be a result of tire and wheel out-of-
balance. Proper balancing will reduce vibration and
avoid tire cupping and spotty wear.

SUPPLEMENTAL TIRE PRESSURE INFORMATION

A light load vehicle condition is defined as two passen-
gers {150 lbs (68 kg) each} plus 200 lbs (91kg) of cargo.
Cold tire inflation pressures for a lightly loaded vehicle
will be found on a “Supplemental Tire Pressure Inflation”
label located on the face of the driver’s door or in the Tire
Information Pressures pamphlet in the glove box.

TIRE CHAINS

Use “Class S” chains on 1500 Ram Trucks, or other
traction aids that meet SAE Type “S” specifications.

Use “Class U” chains on 2500/3500 Ram Trucks, or other
traction aids that meet SAE Type “U” specifications.

NOTE:

Chains must be the proper size for the vehicle,

as recommended by the chain manufacturer.

CAUTION!

To avoid damage to your vehicle, tires or chains, observe the
following precautions:

Because of limited chain clearance between tires and other
suspension components, it is important that only chains
in good condition are used. Broken chains can cause
serious vehicle damage. Stop the vehicle immediately if
noise occurs that could suggest chain breakage. Remove
the damaged parts of the chain before further use.

Install chains as tightly as possible and then retighten
after driving about 1/2 mile (0.8 km).

Do not exceed 45 mph (72 km/h).

Drive cautiously and avoid severe turns and large bumps,
especially with a loaded vehicle.

Do not install tire chains on front wheels of 4x2 vehicles.

Do not drive for a prolonged period on dry pavement.

Observe the tire chain manufacturer’s instructions on
method of installation, operating speed, and conditions
for usage. Always use the lower suggested operating
speed of the chain manufacturer if different than the
speed recommended by the manufacturer.

STARTING AND OPERATING

251

5