Horton Storm RDX - Manual (Page 2)

STORM RDX ASSEMBLY
1
5 7 6
5. Remove the string stop block and its
assembly bolt with washers
(photo 5).
Note: Do not remove the
foot stirrup.
6. Remove the two ¼ - 20 x ¾''
counter-sink screws from the barrel
channel (photo 6).
7. Tilt the riser downward and slide it out
of the barrel (photo 7).
1. Install the cable saver. Note: The long, grooved side of the
cable saver sits on the cables, it does not snap on (photo 1).
2. With the barrel above the riser, slide the cable saver into the
cable slot with the string sliding over the flight deck.
Note: Do not nick or rub the cables or string on the end of
the barrel (photo 2).
3. Insert & tighten the two ¼ - 20 x ¾'' counter-sink screws
connecting the riser to the barrel (photo 3). Verify that both
screws are tight.
Note: The counter-sink screws will not be
flush with, or sink into, the barrel channel holes.
4. Install string stop block, assembly bolt, and lock washer
(photo 4).
5. Install the stock by inserting the ¼ - 20 x 1'' screw in the
front stock screw hole and partially tighten, then the
¼ - 20 x 1 ¾'' screw in the rear hole and partially tighten
(photo 5). Once properly aligned, tighten both screws
completely without over-tightening.
6. Attach the fore-grip and safety wing by inserting the
¼ - 20 x 1'' screw in the front stock screw hole and
partially tighten, then the ¼- 20 x 1 ¾'' screw in the
rear hole and partially tighten (photo 6). Once properly
aligned, tighten both screws completely without
over-tightening.
7. Insert and tighten the #10 x 1'' self-tapping tang screw
(photo 7).
8. Attach the scope and rings to the dovetail mount in the
desired position (photo 8). To avoid lens damage, tighten the
bottom screws on the scope rings first, leaving a slight gap
between the ring sections at the top.
1
5
3
7
2
6
4
8
Remove string stop block. Remove barrel channel screws. Tilt riser and slide it out of
the barrel.
Install cable saver.
Insert barrel channel screws.
Install stock and screws.
Insert tang screw.
Slide cable saver into the
cable slot.
Install string stop block.
Attach fore-grip and safety wing.
Attach the scope.