Dynasty Spas 2007 - Manual (Page 22)

Dynasty Spas Operator’s Guide • www.dynastyspas.com 22
Proper Maintenance For Your Dynasty Spa Cover
1) Use a soft broom to remove accumulation after every snowfall or ice
storm.
2) Splash cool tap water on the hardware to free them if they become frozen
shut. WD-40™ will keep the lock free, but apply carefully because it can
damage the cabinet finish.
3) We recommend a good treatment with Vinyl Conditioner before the first
snow or ice. If possible, treat during the winter too.
4) Monitor your water chemistry. Even it the spa is not used regularly,
improper water chemistry can cause a mildew build-up on the cover.
Clean, PH controlled water will prolong the life of the cover.
5) If mildew is found, remove foam cores from the vinyl encasement. Mix
water, a teaspoon of mild dish washing soap and a cup of bleach. With a
soft bristle brush, scrub the inside and outside of the vinyl encasement
thoroughly. Then take a washcloth and wipe down each foam core, rinse
thoroughly. Place the encasement in the sun and foam cores in the
shade to dry. Once everything is thoroughly dry, spray the cores and
encasement with a mildew inhibitor (like Pine Sol). Allow to dry
completely, then reassemble. The key here, of course, is to maintain
proper water chemistry to avoid mildew.
6) We suggest rotating the cover every six months to maintain even wear.
Unzip the cover, remove the foam cores, turn over and reassemble.
Ask Your Dealer About Using A Cover Caddy
PROTECT YOUR COVER!
MAINTAINING YOUR SPA COVER