DeWalt SDS Plus D25013 - Manual (Page 12)

10
English
Lubrication
Your tool was properly lubricated before leaving the factory. In from
two to six months, depending upon use, take or send your tool to
an authorized service center for a complete cleaning, inspection
and lubrication. Tools used constantly on production jobs will need
relubrication more often. Also, tools “out of service” for long periods
should be relubricated before being put back to work.
Accessories
WARNING: Since accessories, other than those offered by
D E WALT, have not been tested with this product, use of such
accessories with this tool could be hazardous. To reduce the risk of
injury, only D
E WALT, recommended accessories should be used
with this product.
Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center.
MAXIMUM RECOMMENDED CAPACITIES
D25013
Masonry 7/8" (22 mm)
Steel 1/2" (13 mm)
Wood 1-1/8" (30 mm)
OPTIMUM CAPACITY
Masonry 5/32"–1/2"
(4 mm–13 mm)
Repairs
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment (including brush inspection and replacement)
should be performed by authorized service centers or other qualified
service personnel, always using identical replacement parts.
SPECIFICATIONS
D25013
Voltage: 120 V AC~ / 220 V AC~
Frequency: 50-60 Hz
Watts 650 W
RPM: 0–1 550/min
Beats per minute 0–4 550