Delta DBN125 - Manual (Page 9)

9
USING THE TOOL
Complete all steps of PREPARING THE TOOL before using the tool.
This tool is shipped from the factory with a “single sequential actuation”
trigger. To fire, grip the tool firmly to maintain control, position nose of
tool onto work surface, push the tool firmly against work surface to
depress safety (S) Fig. 24, and squeeze trigger to fire a fastener. Allow
tool to recoil away from work surface as fastener is driven. This “single
sequential actuation” method provides the most accurate fastener
placement.
Disconnect tool from air supply before performing
maintenance, clearing a jammed fastener, leaving work area, moving
tool to another location, or handing the tool to another person.
Clean and inspect tool daily. Carefully check for proper
operation of trigger and safety mechanism. Do Not use the tool unless
both the trigger and the safety mechanism are functional, or if the tool is
leaking air or needs any other repair.
OPERATING INSTRUCTIONS
Fig. 24
S