Hoist Fitness HD-1700 - Manual (Page 19)

FINE TUNING:
LOOSEN JAM NUT AND THREAD BOLT
IN/OUT TO GIVE THE CABLE PROPER
TENSION. RE-TIGHTEN JAM NUT.
FINE TUNING:
LOOSEN JAM NUT AND THREAD BOLT
IN/OUT TO GIVE THE CABLE PROPER
TENSION. RE-TIGHTEN JAM NUT.
Page - 18 HD1700 Assembly
OW N E R S
M A N U A L
NOTE:
BE SURE CABLE RUNS BETWEEN
PULLEY AND FRAME BOLT.
NOTE:
BE SURE CABLE RUNS BETWEEN
PULLEY AND FRAME BOLT.
NOTE:
BE SURE CABLE RUNS BETWEEN THE
PULLEY AND THE GUARD PIN.
NOTE:
BE SURE CABLE RUNS BETWEEN THE
PULLEY AND THE GUARD PIN. CC
FINE TUNING:
LOOSEN JAM NUT AND THREAD BOLT
IN/OUT TO GIVE THE CABLE PROPER
TENSION. RE-TIGHTEN JAM NUT.
NOTE: SEE DETAIL -A- FOR INSTALLATION.
FINE TUNING:
LOOSEN JAM NUT AND THREAD BOLT
IN/OUT TO GIVE THE CABLE PROPER
TENSION. RE-TIGHTEN JAM NUT.
NOTE: SEE DETAIL -A- FOR INSTALLATION.
136 13/16” [3475mm] 136 13/16” [3475mm]
CV
25
25
BB
CC
5
CV
K
WARNING:
CABLE BOLT MUST BE THREADED
A MINIMUM OF 1/2” INTO ITS RECEIVER
WITH JAM NUT TIGHTENED SECURELY TO
ENSURE PROPER CONNECTION.
WARNING:
CABLE BOLT MUST BE THREADED
A MINIMUM OF 1/2” INTO ITS RECEIVER
WITH JAM NUT TIGHTENED SECURELY TO
ENSURE PROPER CONNECTION.
NOTE:
BE SURE CABLE RUNS OVER
TOP SIDE OF FRAME BOLT.
NOTE:
BE SURE CABLE RUNS OVER
TOP SIDE OF FRAME BOLT.
DETAIL A
NOTE: when securing (DH), Wrench
Tighten bolts till snug, then back off
1/2 turn or until (DH) swings freely.
DETAIL A
NOTE: when securing (DH), Wrench
Tighten bolts till snug, then back off
1/2 turn or until (DH) swings freely.