HiTi P910L User Manual - Manual (Page 22)

Chapter 4. Error Handling
19
3. Open the open guide unit.
4. Pull out the paper until the paper setting lamp goes off.
Attention:
・ If the paper is used without cutting off the folded section or printed section, paper
jam occurs again or the ink ribbon may snap during printing. Always cut off the
creased section or printed section of the paper.
・ Cut off the paper straight and at right angles to the roll paper direction.
・ If paper jam occurs frequently, a defect in the mechanical section is assumed.
Consult with the service center.
Power Supply Interrupted during Printing
In case, power supply interrupted during the printing, Thermal Head will
be kept pushing to Platen.
Leaving this situation for a long time, shape of Platen can be warped. In
order to avoid this situation, please follow the instruction below.
1. Turn off the power of the printer.
2. Turn on the power for 3 or more seconds after turning off the power.
3. Paper Jam is displayed on the printer status lamps, open the front cover and take the
necessary action according to the instruction provided in 4-2, "Paper Jam".
When the Ribbon is snapped
1. Remove the ink ribbon.
2. Stick the broken part of the ribbon with a tape.
3. Turn the ribbon on the rewinding side and rewind the
taped section completely.
PAPERSET lamp