Hiti p910l quick installation guide – HiTi P910L Quick Installation Guide User Manual
Page 4
HiTi P910L Quick Installation Guide
Installing Dust Box
Insert the claw of the dust box first and
insert the projected section of the printer
in the hole at the bottom of the dust box.
Loading Paper
3. Set the paper in the printer.
Set the paper by matching the color of
the paper flange and the color of the
holder.
After setting the paper, remove the
seal from the paper.
4. Insert the edge of paper under the
guide roller by rotating the paper
flanges. Insert the paper until the
Paper Setting Lamp is lit.
5. Close the open guide unit.
When close the open guide unit, press
on the center of the open guide unit.
6. Close the drawer unit.
When the drawer unit is closed,
initialization starts and four sheets of
paper are ejected automatically.
Transporting the Printer
The following cautions are necessary in
transportation of the printer.
Since an incorrect transportation method
causes a printer fault, follow the correct
method.
1. Remove the ink ribbon and paper from
the printer before transporting the
printer.
If the ink ribbon or paper cannot be
removed due to a fault, consult with
the distributor.
2. Use a genuine box.
If the box used at the purchase cannot
be used, consult with your distributor
and purchase a new box.
PAPERSET lamp
Guide Roller