Guralp Systems Strong Motion - Manual (Page 8)

Strong Motion User Guide
The first hex code could be 77000000 to enable 200sps data on
both sensors (or 07000000 for Sensor A only), 00000077 to
enable only 10sps data, or a combination of any of these
codes. The CMG-DM24 manual can be consulted for further
information.
Finally, enable the remaining strong motion features:
+simode ok_A808
rtstatus enable SQpatch disabled ok_A808
ok-1
Forth Vocabulary now available
Guralp Systems Ltd - DM+FW v.103 mgs 17/10/07 (Build 60)
SYSTEM FORTH ROOT
Current: FORTH
ok_A808
+monitor ok_A808
uspmonitor ok_A808
2.5 Common scenarios
This section holds concise instructions for setting up three
common scenarios. Ensure that you have read the previous
sections and understand what each command does before
issuing these instructions.
1x strong motion sensor
resetlabels
set-id
6 sensor-type
(for CMG-5T)
adaptive
(if desired)
erasefile
normal compression
0 1 bandpass
3 highpass
200 100 20 10 samples/sec
lowlatency
7 triggers
LLstreams enable
set-config
(use e.g. 00070000, 0000)
+simode
rtstatus enable
ok-1
+monitor
uspmonitor
re-boot
2x strong motion sensor
resetlabels
set-id
serial2
8 Issue F