beautypg.com

Canadian programming/gate programming – Dodge 2007 Power Wagon User Manual

Page 144

background image

8. Return to the vehicle and firmly press, hold for two
seconds and release

the programmed HomeLink button.

Repeat the

؆press/hold/release؆ sequence a second time,

and, depending on the brand of the garage door opener
(or other rolling code equipped device), repeat this
sequence a third time to complete the programming.

HomeLink should now activate your rolling code
equipped device.

NOTE:

To program the remaining two HomeLink but-

tons, begin with

ЉProgrammingЉ step two. Do not repeat

step one

. For questions or comments, please contact

HomeLink at www.homelink.com or 1-800-355-3515.

Canadian Programming/Gate Programming

Canadian radio-frequency laws require transmitter sig-
nals to

Љtime-outЉ (or quit) after several seconds of

transmission which may not be long enough for
HomeLink to pick up the signal during programming.

Similar to this Canadian law, some U.S. gate operators are
designed to

Љtime-outЉ in the same manner.

If you live in Canada or you are having difficulties
programming a gate operator by using the

ЉProgram-

ming

Љ procedures (regardless of where you live), replace

؆Programming HomeLink؆ step 3 with the following:

NOTE:

If programming a garage door opener or gate

operator, it is advised to unplug the device during the

ЉcyclingЉ process to prevent possible overheating.
3. Continue to press and hold the HomeLink button
while you press and release every two seconds (

ЉcycleЉ)

your hand-held transmitter until the frequency signal has
successfully been accepted by HomeLink. (The indicator
light will flash slowly and then rapidly.) Proceed with

ЉProgrammingЉ step four to complete.

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

143

3