beautypg.com

Dodge 2007 Power Wagon User Manual

Page 143

background image

3. Simultaneously press and hold both the HomeLink
button that you want to train and the hand-held trans-
mitter buttons. Do not release the buttons until step 4
has been completed.

NOTE:

Some gate operators and garage door openers

may require you to replace this Programming Step 3 with
procedures noted in the

ЉGate Operator/Canadian Pro-

gramming

Љ section.

4. The HomeLink indicator light will flash slowly and
then rapidly after HomeLink successfully receives the
frequency signal from the hand-held transmitter. Release
both buttons after the indicator light changes from the
slow to the rapid flash.

5. Press and hold the just trained HomeLink button and
observe the indicator light. If the indicator light stays on
constantly, programming is complete

and your device

should activate when the HomeLink button is pressed
and released.

NOTE:

To program the remaining two HomeLink but-

tons, begin with

ЉProgrammingЉ step two. Do not repeat

step one.

If the indicator light blinks rapidly for two seconds and
then turns to a constant light, continue with

؆Program-

ming

؆ steps 6-8 to complete the programming of a rolling

code equipped device (most commonly a garage door
opener).

6. At the garage door opener receiver (motor-head unit)
in the garage, locate the

ЉlearnЉ or ЉsmartЉ button. This

can usually be found where the hanging antenna wire is
attached to the motor-head unit.

7. Firmly press and release the

ЉlearnЉ or ЉsmartЉ button.

(The name and color of the button may vary by manu-
facturer.)

NOTE:

There are 30 seconds in which to initiate step

eight.

142

UNDERSTANDING THE FEATURES OF YOUR VEHICLE