Connecting the receiver module (neo-fiberlink-2rx), Start-up – Guntermann & Drunck NEO-FiberLink2 User Manual

Page 9

Start-up

NEO-FiberLink-2 · 6

Connecting the receiver module (NEO-FiberLink-2Rx)

Place the receiver module close to the slave matrix switch.

Transmission – Tx:

Insert the LC plug of the fibre optics, which is available as acces-

sory. Connect the other end of the cable to the Transmission – Rx interface of the

receiver module.

Transmission – Rx:

Insert the LC plug of the fibre optics, which is available as acces-

sory. Connect the other end of the cable to the Transmission – Tx interface of the

receiver module.

Transmission-1 CAT:

Use a CAT5 (or better) twisted pair cable to connect these inter-

faces to a CPU interface of the master matrix switch.

Transmission-2 CAT:

Use a CAT5 (or better) twisted pair cable to connect these inter-

faces to a CPU interface of the master matrix switch.

Red. Power:

If necessary, connect the connection cable of the optional power pack to

this interface. Then connect a power cable to the power pack and a power outlet.

Main Power:

Insert the supplied power cable and connect it to a power outlet.

Start-up

Turn on the master and the slave matrix switch as well as the transceiver and

receiver module of the NEO-FiberLink series.

Main

ower

Red. Power

Transmission-1 CAT

Transmission-2 CAT

to master / higher-level device

Transmission Fiber

Class 1 Laser Product