Gullco GK-200-RLx-I - Manual (Page 7)

5
Standard “KAT”
®
Carriage Indexing System Control Arrangement
Unless specifically requested at time of order, the Gullco “KAT”
®
Indexer System is shipped from
the factory configured with the Cycle Control (Master) located on the left hand side and controlling
the “KAT”
®
carriage, while the Index Control (Slave) is located on the right hand side and controlling
the Motorized Rack Arm (refer to the Technical Manual for details of how to reverse this
arrangement if necessary).
Label identifying the Cycle
Control (Master)
GSP-2010-5
Standard configuration to
cycle the “KAT”
®
Carriage
Label identifying the Index
Control (Slave)
GSP-2010-7
Standard configuration to index
the Motorized Rack Arm
This section of the label identifies
the Programmable
Parameters/Variables applicable
to the Cycle Control (Master)
This section of the label
identifies the Programmable
Parameters/Variables applicable
to the Index Control (Slave)
Standard configuration =
“KAT”
®
carriage cycles forward
& backward between limit
switches
Standard configuration =
indexing of gun/torch by
Motorized Rack Arm at
the end of each cycle
pass