Dimplex DS5804CM - Manual (Page 9)

9
Operation
Resetting The
Temperature Cutoff
Switch
Should the heater overheat, an
automatic cut out will turn the
heater off and it will not come
back on without being reset.
It can be reset by switching
the Main On/Off Switch to Off
and waiting 5 minutes before
switching the unit back on.
CAUTION: If you need to
continuously reset the heater,
unplug the unit and call Dimplex
North America Limited at 1-888-
346-7539.
Remote Control
(Figure 2)
the stove is supplied with an
integrated On/Off remote control,
that is factory syncronized with
the stove.
To operate, push the ON button
to turn stove on, push the OFF
button to turn the stove off . The
amount of heat produced will
be dependant on positioning of
manual heat controls.
!
NOTE: Ensure that the stove’s
On/Off switch is set to the
remote control setting (“ II ”
position).
on
Button
Battery
Cover
OFF
Button
Battery
Figure 2
Initialization/Reprogramming
Follow these steps for remote
control initialization if required:
① Set the main power switch to
OFF.
② Set the 3 Position Switch to
the Remote position (refer to
Operation Section).
③ Wait a minimum of five (5)
seconds and then turn the
main power ON.
④ Within 10 seconds of re-
acquiring power, press the ON
button located on the remote
control transmitter.
! NOTE: You will have only 10
seconds to perform this last