Denon AVR-4806 - Manual (Page 2)

Before Using
• The following buttons are used to operate the XM radio.
2 Checking the XM signal strength and Radio ID
3 Set the input source to “TUNER”.
4
Press the TUNER button on
the remote control unit to
select the TUNER mode.
(Main unit) (Remote control unit) (Remote control unit)
1
5
Watching the display, press the BAND button
to select the XM mode.
(Remote control unit)
Press the POWER switch to turn on the main
unit.
2
Press the ON/STANDBY switch on the main
unit or ON button on the remote control unit.
7
8
6
9
Press the TUNING ª button to select channel 0
(XM000).
• The Radio ID is displayed.
Press the STATUS button on the main unit
until “SIGNAL” is displayed.
• The display changes as shown below according to
the receiving condition.
Press the STATUS button until the XM channel
(ex.XM001) is displayed.
Adjust the antenna location until
“SIGNAL:GOOD” is displayed.
2
Condition Display
GOOD Signal strength is good
MARGINAL Signal strength is marginal
WEAK Signal strength is poor
NO Loss of the signal
ON/STANDBY STATUS
POWER FUNCTION
CURSOR F
CURSOR H
CURSOR D
CURSOR G
ENTER
TUNER
BAND
ENTER
CURSOR F
TUNING •
TUNING ª
CURSOR G
CURSOR
CURSOR
H
D
X M 0 0 0 R A D I O I D
Radio ID
TUNER
(Input source)
ON
SOURCE