Accessories, Attach the bottom panel, Assemble shelves – Gladiator GAGB54SBYG Storage Bench User Manual

Page 5: Install doors

Attach the Bottom Panel

Put on the bottom panel (upside down so the mating edges are
pointing up), and make sure that the four tabs and slots are fully
engaged.

Attach the Phillips-head screws (F3c) between the back panels
(P5) and the bottom panel (P4). Do not tighten the 10-24 Phillips-
head screws (F3c) completely, but tighten the bolts completely.

Install and tighten the four 10-24 wing nuts (F11a) (hand tight)
onto the protruded threads (included on the bottom panel) at
each of the corners (4).

Install the levelers (P6) to the bottom panel (P4).

Tighten all Phillips-head screws (F3c) and all remaining loose
screws from the previous steps.

Assemble Shelves

Using 2 or more people, turn the storage bench over to its upright
position. Assemble the shelves (P7) at your desired location within
the storage bench.

Install Doors

Assemble the door that is on the right (P9) as you face the front
of the storage bench.

ngage the door top to the rail by placing the 2 top pins into the

guides, and then push the pins in (collapse) against the rail

Swing the door bottom down and push in to make the rollers
engage into the bottom rail. Slide the door back and forth several
times to ensure the door is engaged completely.

Repeat steps 2 and 3 to assemble the left door (P8).

ACCESSORIES

To order accessories, call 1-866-342-4089 and ask for the accessory
part number listed below or contact your authorized Gladiator

brand

dealer. In Canada, call 1-800-807-6777.

24" Wire Shelf

Order Part # GAWE24WSSH

F3c

10-24 Phillips-head screw (4)

F11a

10-24 Wing nut (4)