Gladiator GAGB54SBYG Storage Bench - Manual (Page 4)

4
ASSEMBLY INSTRUCTIONS
Bamboo Storage Bench Use Requirements
■ Intended for use in a garage.
■ Maximum weight limit is 35 lbs (15.9 kg) for each shelf.
■ Maximum weight limit is 500 lbs (227 kg) for the bamboo storage
bench.
Unpack Bamboo Storage Bench Parts
1. Remove and verify the contents. Contents include the parts and
fasteners shown in “Parts.”
2. Dispose of/recycle all packaging materials.
Assemble Bamboo Storage Bench Frame
Gather the required tools before starting installation.
Tools Needed:
Tools Supplied:
IMPORTANT:
■ Two people may be required to complete the assembly.
■ The bamboo top (P2) is intentionally designed so that the head of
lag bolts which were pre-assembled on the bamboo top will
match with the loops on the sides only when it is positioned
correctly. If the bolt heads on the bamboo top do not match up
with the loops on the side panel (P3 and P1), turn the bamboo
top around.
1. Place the bamboo top (P2) on floor (upside down, with the
protruding lag bolt heads pointing upward
).
2. Assemble the left-hand panel (P3) slot in the key hole to
protruding lag bolt and pull forward to nest in the small portion of
key hole.
3. Using a wrench, tighten the two lag bolts (which were pre-
assembled onto the bamboo top). Tighten completely.
4. Repeat steps 2 and 3 for the other cabinet side (P1).
Attach Back Panels
1. Slide in the back panel so that the tabs in the back panel are
aligned with the slots of the side panels.
2. Push in and ensure the four tabs are fully engaged in the slots.
3. Attach the four #8 ¹⁄₂" long Phillips-head screws (F15) to the
bamboo top.
4. Attach the two 10-24 Phillips-head screws (F3c) between the
side panels (P3 and P1) and back panel (P5). Do not tighten the
screws completely. This will be done later.
■
¹⁄₂" Wrench
■ Phillips screwdriver
■ Level
WARNING
Excessive Weight Hazard
Use two or more people to move, assemble or install
cabinet.
Failure to do so can result in back or other injury.
P1
P2
P3
F3c F15
F3c 10-24 Phillips-head screw (2)
F15 #8
¹⁄₂" long Phillips-head screw (4)
A. F3c 10-24 Phillips-head screw (2)
B. F15 #8
¹⁄₂" long Phillips-head screw(4)
P1
P2
P3
P5
B
A
A