Workbench safety assembly instructions, Danger warning, Tools and parts – Gladiator GAWB0xMTZG Adjustable Height 4/6/8 ft. Maple Workbench User Manual
Page 2: Workbench use requirements, Unpack the workbench

2
WORKBENCH SAFETY
ASSEMBLY INSTRUCTIONS
Tools and Parts
Gather the required tools and parts before starting installation.
Tools Needed
Parts Supplied—4 ft (121.9 cm), 6 ft (182.9 cm), or 8 ft
(243.9 cm) Workbench
Workbench Use Requirements
■
Intended for use in a garage.
■
Maximum weight limit is 3,000 lbs (1,360.8 kg) for the
workbench.
Unpack the Workbench
1.
Unpack the legs and hardware from the box. Verify contents. See
“Parts Supplied.”
2.
Remove the back panel and set it aside.
NOTE: Leave the workbench top on the cardboard during
assembly.
3.
Remove the corners from the workbench top. The bolt holes
should be visible.
4.
Dispose of/recycle all packaging materials.
You can be killed or seriously injured if you don't immediately
You
can be killed or seriously injured if you don't follow
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”
These words mean:
follow instructions.
instructions.
DANGER
WARNING
■
⁹⁄₁₆" socket wrench
■
⁷⁄₁₆" wrench
■
Adjustable wrench
■
P1—Workbench outer legs
(2 welded sets)
■
P2—Workbench inner legs (4)
■
P3—Workbench back panel
■
P4—Workbench top
■
P5—Spacers (8)
■
P6—Leveling legs (4)
■
F14—
¹⁄₄" – 20 x ³⁄₄" bolts (4)
■
F16—
³⁄₈" x 1¹⁄₂" screws (11)
■
F17—Wing nuts (8)
■
F18—
⁵⁄₁₆" hex-head bolts (8)
■
F19—
⁵⁄₁₆" washers (8)
■
F20—
¹⁄₄" lock washers (4)