Dixon RAM 42 2005 - Manual (Page 29)

OPERATION INSTRUCTIONS
29
TESTING OF SAFETY INTERLOCK SYSTEMS:
BLADE DRIVE SWITCH TEST:
a) Put parking brake in ON position.
b) Swing control levers to outward position.
c) Engage blade drive switch.
d) Turn ignition switch to START.
Engine should not turn over or attempt to start.
SEAT SWITCH TEST:
a) In a SAFE AREA away from bystanders, start the
engine.
b) Leave control levers in outward position and put
parking brake ON position.
c) Engage blade drive.
d) Raise slightly off seat.
ENGINE SHOULD STOP!
NOTE: If any safety check fails, do not operate the
mower until the system has been checked and repaired
by an Authorized Dixon® Dealer.
Failure to observe the following testing instructions
could result in serious injury or death.
The following tests should be performed at the start
of each mowing day.