Dodge 2008 PM Caliber - Manual (Page 101)

Voice Training
For users experiencing difficulty with the system recog-
nizing their voice commands or numbers, the UConnect
௡
system Voice Training feature may be used. To enter this
training mode, follow one of the two following proce-
dures:
From outside the UConnect ௡ mode (e.g., from radio
mode):
• Press and hold the “Voice Recognition” button for five
seconds until the session begins, or,
• Press the “Voice Recognition” button and say the
ЉSetup, Voice TrainingЉ command.
Repeat the words and phrases when prompted by the
UConnect
௡ system. For best results, the Voice Training
session should be completed when the vehicle is parked
with the engine running, all windows closed, and the
blower fan switched OFF.
This procedure may be repeated with a new user. The
system will adapt to the last trained voice only.
To restore the Voice Recognition system to factory default
settings, enter the Voice Training session via the above
procedure and follow the prompts.
Voice Recognition (VR)
• For best performance, adjust the rearview mirror to
provide at least 1 ⁄
2
in (1 cm) gap between the overhead
console (if equipped) and the mirror.
• Always wait for the beep before speaking.
• Speak normally, without pausing, just as you would
speak to a person sitting a few feet/meters away from
you.
• Make sure that no one other than you is speaking
during a voice recognition period.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 99
3