Warning, Attach back panels, Install leveling legs or casters – Gladiator GAGB28FDYG Full-Door GearBox User Manual

Page 4

Tools Needed:

Tools Supplied:

IMPORTANT:

■

Two people may be required to complete the assembly.

■

As you assemble the cabinet, make sure the edges with the
holes are facing up.

■

If you are assembling the cabinet on the floor, fasten the eight
front corner bolts, two at each corner, after you stand the cabinet
upright.

Place side panel (P1) on a flat, firm surface so that the edge with
the holes is facing up as shown.

Insert the cabinet top (P2) between the edges of side panel (P1).
NOTE: Make sure the edges with the holes are facing up.

Align the holes and attach the top (P2) to side panel (P1) using
Allen-head bolts (F1) and

⁵⁄₁₆"

flange nuts (F2) as shown. Do not

tighten completely.

Position side panel (P3) so that the top (P2) is between the edges
of side panel (P3).

Align the holes and attach the top (P2) to the side (P3) using
Allen-head bolts (F1) and

⁵⁄₁₆"

flange nuts (F2) as shown. Do not

tighten completely.

Insert cabinet bottom (P4) between the edges of side panels
(P1 and P3).
NOTE: Make sure the edges with the holes are facing up.

Align the holes and attach the bottom (P4) to the side panels
(P1 and P3) using Allen-head bolts (F1) and

⁵⁄₁₆"

flange nuts (F2)

for each side as shown. Do not tighten completely.

Attach Back Panels

Align lower back panel (P6) with the holes in the cabinet
bottom (P4). Using Phillips-head screws (F3b), attach back panel
(P6) to the bottom (P4) and sides (P1 and P3) as shown. Do not
tighten screws completely.

Align upper back panel (P5) with the holes in the cabinet top (P2).
Using Phillips-head screws (F3b), attach back panel (P5) to the
top (P2) and sides (P1 and P3) as shown. Do not tighten screws
completely.
NOTE: Upper back panel (P5) will slightly overlap lower back
panel (P6).

Using Phillips-head screws (F3b), attach the upper back panel
(P5) to the lower back panel (P6) as shown.

Completely tighten all back panel screws starting with the sides
and continuing with the top, middle, and bottom.

Using the Allen wrench (provided), completely tighten all the
cabinet bolts and nuts.

Install Leveling Legs or Casters

The Gladiator

Modular Cabinet is designed to be either stationary or

to roll on casters.
IMPORTANT: If you decide to install the casters on the cabinet, see
the installation instructions included with the caster kit (provided).
To install leveling legs:
1.

Place the cabinet on its side.

■

¹⁄₂" Wrench

■

³⁄₈" Wrench

■

¹¹⁄₃₂" Wrench

■

Phillips screwdriver

■

Pliers

■

Level

■

Allen wrench

■

Key

WARNING

Excessive Weight Hazard

Use two or more people to move, assemble or install
cabinet.

Failure to do so can result in back or other injury.

F3b

F3b Phillips-head screw (16 - black)