Gladiator GABK362PSS Ready-To-Assemble Cabinet Bracket Kit - Manual (Page 3)

3
Attach Mounting Brackets
Attach to Large GearBox
IMPORTANT: There are holes in back panels (AAA, CCC, and DDD)
to attach the mounting brackets.
1.
With the mounting bracket rims pointing down, align the three
bracket holes with the holes in the top back panel (AAA), as
shown.
2. Working from the back, insert carriage bolts (F7) through the
bracket and into top back panel (AAA).
3. Working from the cabinet interior, fasten each bolt with a
washer (F8) and a flange nut (F2). Fully tighten the bolts.
4. Repeat Steps 1 and 2 to attach the center and bottom mounting
brackets to the back of the cabinet.
NOTE: Hand tighten the nuts attaching the center and bottom
brackets. These brackets will need to be adjusted to mount the
cabinet on the wall.
Attach to Extra Large GearBox
1. With the mounting bracket rims pointing down, align the three
bracket holes with the slots in the top back panel (P9), as shown.
2. Working from the back, insert carriage bolts (F7) through the
bracket and into top back panel (P9).
3. Working from the cabinet interior, fasten each bolt with a
washer (F8) and a flange nut (F2).
NOTE: For the top bracket only, slide the bolts to the top of the
slot before fastening.
4. Fully tighten the bolts.
5. Repeat Steps 1 through 3 to attach the center bracket to the
third back panel and the bottom mounting bracket to the fifth
back panel as shown.
NOTE: Hand tighten the nuts attaching the center and bottom
brackets. These brackets will need to be adjusted to mount the
cabinet on the wall.
F7 F8 F2
F7 Carriage-head bolt (9)
F8 Washer (9) F2 ⁵⁄₁₆ " Flange nut (9)
A. Bracket rims pointing down
AAA
P1
A
P2
P1
P2
BBB
AAA
A. Bracket rims pointing down
P9
P1
A
P2
P1
P2
P9
P9