Gladiator GAWG302DRG Premier Series 30 Wall GearBox - Manual (Page 3)

3
24" (60.96 cm) Cabinet
Attach Bracket
1. With the rims of a mounting bracket pointing down, align the
holes in the bracket with the pair of holes in the back panel.
2. Working from the back, insert a carriage bolt through the bracket
and back panel as shown.
3. Working from the cabinet interior, fasten each bolt with a washer
and a hex nut. Completely tighten the nuts.
Install Cabinet
IMPORTANT: If installing cabinet on GearTrack™ channel, a second
channel should be installed 18" (45.72 cm) below the bottom of the
supporting channel so the cabinet will hang level.
1.
Close the cabinet door.
2. Determine cabinet mounting location on a GearWall ® panel or
GearTrack™ channels.
3. Using two or more people, engage the mounting bracket into the
wall slots by lifting up, pushing toward the wall and lowering the
bracket rims into the slots as shown.
4. Make sure the mounting bracket is fully engaged in the slots as
shown.
5. If you want to reverse the door, see “Reverse Door.”
6. Permanently affix the magnetic latch to the cabinet by removing
the paper backing from the adhesive and firmly pressing it to the
cabinet.
30" (76 cm) Cabinet
Attach Brackets
1. With the rims of a mounting bracket pointing down, align the
holes in the bracket with the pair of holes in the back panel.
2. Working from the back, insert a carriage bolt through the bracket
and back panel.
3. Working from the cabinet interior, fasten each bolt with a washer
and a hex nut. Completely tighten the nuts.
4. With the rims of the mounting bracket pointing down, align the
holes in the bracket with the pair of slots in the back panel.
5. Working from the back, insert a carriage bolt through the lower
bracket and back panel.
6. Working from the cabinet interior, fasten each bolt with a washer
and a hex nut. Only hand tighten the nuts. The lower bracket will
need to be adjusted to mount the cabinet on the wall.
IMPORTANT: Completely tighten the nuts on the lower bracket
after mounting the cabinet on the wall.
Install Cabinet
1. Close the cabinet doors.
2. Determine cabinet mounting location on GearWall ® panel or
GearTrack™ channels.
3. Using two or more people, engage the top mounting bracket into
the wall slots by lifting up, pushing toward the wall and lowering
the bracket rims into the slots as shown.
4. Make sure the top mounting bracket is fully engaged in the slots
as shown.
5. Open the cabinet doors.
6. From the cabinet interior, lift up on the two lower bolts to adjust
the lower mounting bracket so that it aligns with the slots on the
GearWall
® panel or GearTrack™ channels.
7. Push the cabinet toward the GearWall ® panel or GearTrack™
channels and lower the lower bracket rims into the slots.
8. Make sure the bottom mounting bracket is fully engaged in the
slots.
9. Using a ¹⁄₂" wrench, tighten the two nuts on the bottom wall
mounting bracket.
A. Carriage bolts
B. Bracket rim
A. Bracket rim
B. Slot C. Mounting bracket
fully engaged
B
A
A
B
C
A. Bracket rim
B. Slot C. Mounting bracket
fully engaged
A
B
C