Dometic RM2500 - Manual (Page 12)

INSTRUCTIONS FOR MOUNTING THE DOOR PANEL
The refrigerator is normally delivered without door panel(s).
Before starting the mounting work check that the panel dimen-
sions are in compliance with those given in the table and read the
instructions through. When mounting the panel, proceed as
follows.
A.
B.
C.
D.
E.
F.
Remove the door decoration list (2) with its two screws (1).
The upper corners of the upper panel (2door models) and
the lower comers of the lower panel has to be cut according
to the sketch.
Insert one of the vertical edges of the panel into the groove
of the door frame (3).
Rend the panel gently so that the free side of the panel can
be slipped into the corresponding groove of the door frame
(4).
Push the panel downwards so that the lower horizontal
edge of the panel is fitted into the bottom groove (5).
Between the upper edge of the panel and the door frame
there is now a gap which should be covered by the decora-
tion strip.
Put the strip across the door so that the gap is covered and
push it upwards (6).
The tabs on the inside of the strip should fit in behind the
flange of the door frame. Secure the decoration strip by
means of the two screws (1).
Panel dimensions
Thickness max. 4 mm 5/32 inches
REFRIG. HEIGHT WIDTH
MODELS + 1- 1/32 inch +1- 1/32 inch
RM2366 25 1/2 21 1/16
RM2400 28 1/16 22 13/32
RM2500 35 15/16 22 13/32
RM2600