GAMMA PROGRESSION Els STRINGING MACHINE (Issue 1 - March 2009) - Manual (Page 5)

4
POWER CONNECTION & CONTROLS
Front Panel Features
A - String Gripper
B - Tension Switch
C - L.E.D. Tension Display
Back Panel Features
A - Lighted Power Switch
B - Foot Pedal Switch Receptacle
C - A/C Power Cord Socket
D - String Length Meter (currently not
available)
B
C
A
C B
A
WARNING! FOR INDOOR USE ONLY. TO BE USED BY
ADULTS OR UNDER ADULT SUPERVISION ONLY.
NEVER OPEN UNIT WITH POWER CONNECTED
Instructions for Power Connection and Controls
CAUTION ! Before connecting to the power supply, check the voltage source that the
machine is being connected to. The acceptable range of input voltages for this
machine is between 100 V and 240 V @ 50 to 60 Hz. If you have any questions
regarding the input voltage supply for your area, please ask your electric utility
company.
To install the power cord, insert the female end of the power cord into the AC Adapter and
then insert the female end of the cord from the AC Adapter into the A/C Power Cord
Socket “C” located on the back panel of the tensioner. Plug the male end of the power
cord into a grounded power outlet. When using extension cords, use grounded heavy duty
extension cords rated for 15 AMP service.
To connect the foot pedal switch, insert the male pin at the end of the foot pedal switch
cord into the Foot Pedal Switch Receptacle “B” located on the back panel of the tensioner.
Switch on the machine by pressing the Lighted On-Off Power Switch on the back panel. At
start-up, the LED will display a countdown from “9.0” to “0.0” while the machine performs a
self diagnostics check at start-up.
D