GAMMA PROGRESSION 200 STRINGING MACHINE (Issue 1 - July 2010) - Manual (Page 6)

6
Adjusting the Frame Support Posts
Place the racquet frame over the center posts
and onto the frame support posts. Loosen the
locking screws on one support post and slide
the post in the appropriate direction until the
plastic adapter contacts the frame. Securely
tighten the locking screws. Adjust the opposite
post in the same manner.
Note: It is extremely important both plastic
adapters are in contact with the frame to
prevent racquet damage.
MOUNTING THE RACQUET
Installing the Racquet Support
Adapters
The machine is supplied with two styles of
Racquet Support Adapters. A thick profile
adapter for wide body racquets and a thin
profile adapter for conventional racquet
frames. The Adapters are also tapered, use
the highest side of the adapter that does not
interfere with the string grommet holes.
Securing the Racquet
With the frame support posts properly ad-
justed, place the frame hold down clamps
over the center screws and tighten the clamp
bar knobs securely. Do not overtighten the
knobs as frame damage may occur.
Note: Inverted throat racquet frames may
require the throat clamp plate to be rotated
180 degrees to match the frame.