beautypg.com

Fulgor Milano CHD 9003 TC User Manual

Page 14

background image

14

15

GB

The hood may be installed in the filtering or in the

ducting version.

Exhausting version (Fig.1) the hood aspirates

the kitchen air saturated with fumes and odours,

purifies it through the grease filters and expels

it through an outlet pipe. With his version the

charcoal filters are not required.

Filtering version (Fig.1A) the hood aspirates

the kitchen air saturated with fumes and odours,

purifies it through the grease filters and the

charcoal filters and returns clean air into the

room.

The charcoal filters are not supplied.

Decide from beginning on the type of

installation.

For greater efficiency, we recommend to

install the hood in exhausting version.

Use gloves during installation and

maintenance operations.

In case of exhausting version it is important :

- to prepare the hole and the duct of 150

mm.diameter

- to use a duct with the minimal indispensable

length

- to use a duct with few curves as possible (max

curve angle 90°)

- to avoid to use flat ducts or with different

sections

- to use a duct with the smoother surface inside

and of a certified material

- don’t connect the hood to fumes exhaust ducts

(fireplaces, boilers, stoves,…)

- the air can not be evacuated into a wall hole, if

this hole is not dedicated to this purpose

- to equip the room of air intakes in order to not

create air depression (it must not exceed the

0,04 mbar)

CONTROLS

A B C D E F G H I

A) ON/ OFF motor (it switches the hood on

the second speed)

B) 1st motor speed

C) 2nd motor speed

D) 3rd motor speed

E) 4th motor speed

F) ON/OFF lamps: if pressed long, it permits

to select 3 different levels. Last selected

level will remain in memory when the

cooker hood restarts. If the product is

equipped with led lamps, it is not possible

to select the different levels; therefore the

function is only ON/ OFF.

G) TIMER: it permits to select 3 several

ranges(10’, 15’, 20’ minutes)

H) *Filter alarm

I) Remote control signal receiver

*Filter alarm:

the first operation once you have connected the

coke hood to the net, is to set it into exhausting or

recycling mode. Proceed as follows:

once the cooker is connected all the keys will

light for some seconds: press the key on/off

for around 8 seconds until that the key H is not

lighted. Press the key B if you want that the

cooker hood works in exhausting mode (on this

way the charcoal filters counter is not working

because not considered); the red key H is blinking

and you can confirm pressing it.

To set the coke hood into recycling mode (grease

filters and charcoal filters counter) you must press

the key C after the 8 seconds and the key H will

be lighted red fix; pressing on it you can confirm.

After 30 hours working, the key H will light fix:

this means that it is time to clean the grease

filters. After 140 hours working the key H will blink

This manual is related to the following products: