Care and maintenance, Temperature setting for single zone, For dual zone – Fulgor Milano FWC 4524 TC User Manual

Page 28: Cleaning the wine cooler

TEMPERATURE SETTING
For Single Zone

• The temperature setting range is 5-22 ºC (41-72 ºF).
• Directly touch the

mark to set the wine cooler temperature as you want.

• The first touch on

mark will recall the previous set temperature displayed in the digital

window. If the appliance runs after a power failure (or unplugging), the previous set temperature
does not exist and is replaced by the defaulted temperature at 12ºC.

• Touch the mark

to increase the set temperature by 1ºC. On the contrary, touch the mark

decrease the set temperature by 1ºC.

• The digital will change to display the real temperature of the inside cabinet after

10 seconds

without being touched.

Note: For the first time to use the appliance or to restart the appliance after having been shut off for
a long time, you may find a few degrees variance between the set temperature and the displayed
temperature. It is normal and everything of the appliance will be in the order after a few hours running

SELECTING FAHRENHEIT(ºF) & CELSIUS (ºC) DISPLAY
For Single Zone

Touch the marks

with 2 fingers at the same time and hold for 5 seconds, you can interchange

the Fahrenheit and Celsius display.

For Dual Zone

Directly touch the mark

, you can interchange the Fahrenheit and Celsius display for both zones at

the same time.

CARE AND MAINTENANCE

CLEANING THE WINE COOLER

• Turn off the power, unplug the appliance, and remove all items.
• Wipe the inside surfaces with a sponge and baking soda solution. The solution should be about 2

tablespoons of baking soda to a quart (approx. 1 litre) of warm water.

• Wash the shelves with a mild detergent solution. Allow wooden shelves to dry.
• Wring excess water out of the sponge or cloth when cleaning area of the controls, or any electrical

parts.

• Wipe the outside cabinet with warm water and mild liquid detergent. Wipe dry with a clean soft

cloth.

• Do not use steel wool or steel brush on the stainless steel. These will contaminate the stainless

steel with steel particles and rusting may occur.