Fulgor Milano CPH 401 BQ TC - Manual (Page 16)

16 17
GB
Installation
These instructions are provided for qualified installers as
a guide to installation, adjustment and maintenance in
conformity with current laws and standards. Service must
always be performed with the appliance disconnected
from the electricity.
Operation (Fig. 3 and 4)
The appliance is designed to be built in to a work surface
as shown in the figure. Prepare the edge of the hob with
the sealant provided (Fig. 5).
Electrical connection
Before connecting to the electricity, make sure that:
- the characteristics of the system match the data on
the bottom of the hob;
- the system has an effective earth connection
compliant with current standards and laws. An earth
connection is required by law.
- If the appliance has no cable and/or plug, use
material suitable for the absorption indicated on the
registration plate and for the working temperature.
The cable must not reach a temperature higher than
50 °C above room temperature in any point.
- For direct connection to the mains, it is necessary
to provide a device that ensures disconnection from
the mains, with an open distance of the contacts that
allows complete disconnection under Category III
conditions, conforming to the installation rules.
- The omnipolar plug or switch must be easy to reach
when the appliance is installed.
- The appliance is NOT intended for use with an
external timer or a separate remote control system.
- If it is necessary to replace the power cord of the fryer,
use only an oil-resistant type H05RN-F or H07RN-F
cable.
- If it is necessary to replace the power cord of the
barbecue, use an H05RR-F type cable or equivalent.
Note: The manufacturer declines all liability if the
usual accident prevention standards and the above
instructions are not followed.
Installation instructions