FSR CI-5UT - Manual (Page 3)

TECHNICAL SPECIFICATIONS
VIDEO INPUT
Number/type:
1 VGA / SVGA / XGA / SXGA / UXGA /
RGBHV / RGBS / RGsB / RsGsBs
Connectors: One 15 pin HD female
Level (nominal): Analog 0.7 Vp-p
Level (maximum): 2 Vp-p
Impedance: 75 ohms
EQUALIZED VIDEO OUTPUT
Number/type:
1 VGA / SVGA / XGA / SXGA / UXGA /
RGBHV / RGBS / RGsB / RsGsBs
Connectors: 5 female BNC’s ( RGBHV )
Bandwidth: 400 MHz @ -3 dB
100' cable 180 MHz @ +/-0.5dB
150' cable 150 MHz @ +/-0.5 dB
Level (nominal): Unity / User adjustable via HI / LOW / OFF
Jumper
Gain: HI = 125’ to 175’, LOW = 60’ to 125’, OFF
= 0’ to 60’
Impedance: 75 ohms
Design Cable: West Penn WP8255 or equal
LOCAL VIDEO OUTPUT
Number/type:
1 VGA / SVGA / XGA / SXGA / UXGA /
RGBHV / RGBS / RGsB / RsGsBs
Connectors: One 15 pin HD female
Bandwidth: 320MHz @ 03dB
Gain: Unity (buffered)
Impedance: 75 ohms
AUDIO
Bandwidth:
20 Hz to 20 kHz (+/-0.05 dB)
THD + Noise: 0.01% @ 20 kHz at rated Max Output S/N>98 dB
Noise Floor: < 98 dB
Stereo separation: -90 dB @ 1 kHz
INTRODUCTION
Ideal for podiums and conference room settings, the FSR CI-5UT,
takes the worry out of signal loss due to long cable runs. The CI-
5UT interfaces with computer video and audio applications
providing signal amplification and balanced audio output for noise-
free presentations.
The CI-5UT runs the computer video through an active line driver
equalized for the specific cable and sends it out through 5, high
resolution BNC connectors, eliminating signal loss in situations
where cable runs are more than 25 feet. A second fully buffered
out-put is available on a HD-15 connector for local monitoring.
The unbalanced stereo output is actively balanced to eliminate noise
and audio cross talk. It is then output to a 5 position Phoenix
connector.
The CI-5UT also functions as a universal interface when connected
to any FSR seamless switcher, allowing for one central connection
point for composite, S-Video component video and RGB.
The CI-5UT is designed with brackets to mount the unit under the
table which provides an unobtrusive way to hook up a laptop to a
presentaton system. Of course the unit can also be placed on the
table top.
If the CI-5UT is mounted under the table a more convenient way to
hookup a laptop (or equivalent device) would be to use the T-3U
Table Box with the pull out cable. This arrangement provides the
convience of the table top box with the advanced electronics of the
CI-5UT.