Dolmar HT-2556 D - Manual (Page 16)

16
Pos. DOLMAR-No. Qty. Denomination
1 377 601 400 1 Tank cap, cpl.
2 38 650 390 1 Suction head
3 374 300 401 1 Air filter insert
4 381 014 981 1 Spark plug
- 944 340 001 1 Screwdriver
- 944 350 000 1 Grease gun
Extract from the spare parts list
Use only original DOLMAR parts. For repairs and
replacement of other parts, see your DOLMAR service centre.
Malfunction System Observation Cause
cutter does not move Clutch Engine runs Clutch damaged
cutter gets very hot cutter High heating Insufficient cutter slide play
Engine does not start or Ignition system Ignition spark Malfunction in fuel supply system, com-
only with difficulty pression system, mechanical malfunction.
No ignition spark Switch on STOP, fault or short-circuit in the
wiring, plug cap or spark plug defective.
Fuel supply
Fuel tank is filled Carburetor defective, suction head dirty,
fuel line bent or interrupted
Compression Inside Cylinder base packing ring defective, radial
system shaft packings defective, cylinder or piston
rings defective
Outside Spark plug does not seal.
Mechanical
malfunction Starter does not engage Spring in starter broken, broken parts inside
the engine.
Warm start difficulties Carburetor Fuel tank is filled Wrong carburetor adjustment.
Ignition spark
Engine starts, but Fuel supply Fuel tank is filled Wrong idling adjustment, suction head
dies immediately or carburetor dirty
Tank venting defective, fuel line interrupted,
cable defective, ON/OFF switch defective.
Insufficient power Several systems Engine is idling Air filter dirty, Carburetor dirty
may be involved muffler clogged, exhaust
simultaneously channel in cylinder clogged
Trouble shooting