Foxconn G41AP - Manual (Page 22)

15
2
15
Audio Connector : CD_IN
CD_IN is a Sony standard audio connector, it can be
connected to a CD/DVD-ROM drive through a CD/
DVD audio cable.
CoM Connector : CoM2
User must purchase another RS232 cable with a 9-
pin D-sub connector at one end to connect with the
external RS232 device and another end with 10-pin
female connector to connect with COM2 connector in
the motherboard.
Audio Connector : f_AUDIo
The audio connector supports HD Audio standard. It
provides the Front Audio output choice.
fan Connectors : CPU_fAN, SYS_fAN
There are two main fan headers on this motherboard.
The fan speed can be controlled and monitored in
“PC Health Status” section of the BIOS Setup. These
fans can be automatically turned off after the system
enters S3, S4 and S5 sleeping states.
Serial ATA Connectors : SATA_1/2/3/4
The Serial ATA connector is used to connect with SATA
Hard Disk or CD devices which support this feature.
The current Serial ATA II interface allows up to 300MB/s
data transfer rate.
Speaker Connector : SPeAKeR
The speaker connector is used to connect speaker of
the chassis.
COM2
RLSD
SOUT
RI
GND
RTS
DSR
DTR
CTS
EMPTY
SIN
1 2
10 9
CPU_FAN/SYS_FAN
GND
POWER
SENSE
CONTROL
1
GND
TX+
TX-
GND
RX-
RX+
GND
1
SATA_1/2/3/4
NC
SPKJ
EMPTY
SPEAKER
SPKJ
CD_IN
CD_L GND CD_R
1
PORT1_L
PORT1_R
PORT2_L
SENSE_SEND
SENSE1_RETURN
PRESENCEJ
EMPTY
SENSE2_RETURN
AUD_GND
1 2
10 9
F_AUDIO
PORT2_R