beautypg.com

Installation – Desa BG30PT User Manual

Page 10

background image

www.desatech.com

114683-01B

10

INSTALLATION

Continued

Figure 8 - Mounting Bracket Clearances

Attaching Mounting Bracket To Wall
Note:

Wall anchors, mounting screws and spacers

are in hardware package. The hardware package

is provided with heater.
Attaching To Wall Stud Method
For attaching mounting bracket to wall studs
1. Drill holes at marked locations using 9/64"

drill bit.

2. Place mounting bracket onto wall. Line up last

hole on each end of bracket with holes drilled

in wall.

3. Insert mounting screws through bracket and

into wall studs.

4. Tighten screws until mounting bracket is

firmly fastened to wall studs.

Figure 9 - Folding

Anchor

Figure 11 - Mounting Heater Onto

Mounting Bracket

Stand-
Out Tab

32"

Min.

12"

Min.

14"

A

dj

oi

ni

ng

W

al

l

Only Insert Mounting

Screws Through Last

Hole On Each End

Floor

Figure 10 - Popping

Open Anchor Wings

For Thin Walls

Mounting Bracket
(attached to wall)

Horizontal Slots

Attaching To Wall Anchor Method
For attaching mounting bracket to hollow walls

(wall areas between studs) or solid walls (concrete

or masonry)
1. Drill holes at marked locations using 5/16"

drill bit. For solid walls (concrete or masonry),

drill at least 1" deep.

2. Fold wall anchor as shown in Figure 9.
3. Insert wall anchor (wings first) into hole. Tap

anchor flush to wall.

4. For thin walls (1/2" or less), insert red key

into wall anchor. Push red key to “pop” open

anchor wings. IMPORTANT: Do not hammer

key! For thick walls (over 1/2" thick) or solid

walls, do not pop open wings.

5. Place mounting bracket onto wall. Line up

last hole on each end of bracket with wall

anchors.

6. Insert mounting screws through bracket and

into wall anchors.

7. Tighten screws until mounting bracket is

firmly fastened to wall.

2. Mark screw locations on wall (see Figure 8).

Note:

Only mark last hole on each end of

mounting bracket. Insert mounting screws

through these holes only.

3. Remove tape and mounting bracket from

Placing Heater On Mounting Bracket
1. Locate two horizontal slots on back panel of

heater.

2. Place heater onto mounting bracket. Slide

horizontal slots onto stand-out tabs on mount-

ing bracket.

This manual is related to the following products: