Foxconn 661FXME - Manual (Page 5)

5
The audio interface provides two kinds of audio
output choices: the Front Audio, the Rear Audio.
Their priority is sequenced from high to low (Front
Audio to Rear Audio). If headphones are plugged
into the front panel of the chassis (using the
Front Audio), then the Line-out (Rear Audio) on
the rear panel will not work. If you do not want to
use the Front Audio, pin 5 and 6, pin 9 and 10
must be SHORT, and then the signal will be
sent to the rear audio port.
7. Front Audio Connector: F_AUDIO
The serial ATA connector is used to connect the
Serial ATA device to the motherboard. These
connectors support the thin Serial ATA cable for
primary internal storage devices. The current
Serial ATA interface allows up to 150MB/s data
transfer rate.
5. Serial ATA Connector: SATA1, SATA2
CD_IN is Sony standard CD audio connector, it
can be connected to a CD-ROM drive through a
CD audio cable.
6. CD_IN Connector: CD_IN
F_ AUDIO
MIC_IN MIC_GND
MIC_PWR +5VA
AUD_OUT_R AUD_RET_R
AUD_OUT_L AUD_RET_L
1 2
9 10
Empty NC
S A T A 1 / S A T A 2
GND
GND
GND
RX+
RX-
TX+
TX-
1
CD_IN
CD_R
GND
CD_L
1