Foxconn 661FXME - Manual (Page 4)

4
You can clear CMOS to restore default system
setting. To clear the CMOS, follow the procedures
described below.
1. Turn off the AC power and connect pin 1 and 2
together using the jumper cap.
2. Return the jumper setting to normal (pin 2 and
3 together with the jumper cap).
3. Turn the AC power supply back on.
The default status for J2 is open, which supports
the Prescott and Northwood CPU. If J2 set as
close, then it supports the Willamette CPU.
CLS_CMOS
1. Clear CMOS Jumper: CLS_CMOS
2. CPU Model Selection Jumper: J2
Plug the CPU cooling fan cable into the 3-pin
CPU_FAN power supply on the mainboard. Con-
nect the case cooling fan connector to FAN1.
4. FAN Connectors: CPU_FAN, FAN1
Attach the power LED, IDE LED, reset switch and
power switch connectors to the corresponding
pins.
3. Front Panel Connector: FP1
Normal
(default)
1
Clear CMOS
1
NC
IDE-LED+
GND
PLED+
PWRBTN#
PLED-
GND
IDE-LED-
EMPTY
RESET
1 2
9 10
FP1
J2
Open
(Default)
1 2
Close 1 2
FAN1
SENSE
+12V
GND 1
CPU_FAN
GND
+12V
SENSE
1