Foxconn H55A - Manual (Page 22)

15
2
15
CoM Connector : CoM1
This motherboard supports one serial RS232 COM
port for legacy compatibility. User must purchase
another RS232 cable with a 9-pin D-sub connector at
one end to connect with the external RS232 device and
another end with 10-pin female connector to connect
with COM1 connector in the motherboard.
fan Connectors : CPU_fAN, SYS_fAN1/2
There are three main fan headers on this mother-
board. The fan speed can be controlled and moni-
tored in “PC Health Status” section of the BIOS Set-
up. These fans can be automatically turned off after
the system enters 3, S4 and S5 sleeping states.
We recommend you using an 8-pin ATX 12V power supply. If
you are using a 4-pin power supply, you need to align the ATX
power connector according to the picture on the right.
CA
UT
IO
N
! Connect a 4-pin
power plug
CPU_FAN/SYS_FAN1/2/3
GND
POWER
SENSE
CONTROL
1
RLSD
SOUT
RI
GND
RTS
DSR
DTR
CTS
EMPTY
SIN
1 2
10 9
COM1
IDe Connector : PIDe
With the provided Ultra DMA IDE ribbon cable, you
can connect to any IDE type of hard disk and CD/DVD
ROM/RW drive.