Foxconn H55M-S - Manual (Page 42)

3
35
SuperIO Configuration
► Serial Port1 Address
This item is used to assign the I/O address and interrupt request(IRQ) for the onboard serial
port1.
► Serial Port2 Address
This item is used to assign the I/O address and interrupt request(IRQ) for the onboard serial
port2.
► Parallel Port Address
This item is used to assign the I/O address and interrupt request(IRQ) for the onboard parallel
port.
► Parallel Port Mode
This item is used to select the operation modes for the onboard parallel (or Printer) port. They
are [Normal] (default), [EPP], [ECP] and [ECP+EPP].
► Parallel Port IRQ
This item is used to assign interrupt request(IRQ) for the onboard parallel port.
► OnBoard CIR Port
This item enables you to determine the transfer mode of the onboard infrared chip.
CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
SuperIO Configuration
SuperIO Configuration Help Item
Serial Port1 Address Allows BIOS to Select
Serial Port2 Address [2F8/IRQ3] Serial Port1 Base.
Parallel Port Address [378] Addresses
Parallel Port Mode [Normal]
Parallel Port IRQ [IRQ7]
OnBoard CIR Port [Disabled]
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[3F8/IRQ4]