Formax FD 260-20 User Manual
Page 15

11
3. Place 1 HAIRPIN CLIP on the WHEEL SHAFT. Place
1 WHEEL on the WHEEL SHAFT next to the
HAIRPIN CLIP. Continue until all 3 WHEELS are on
the WHEEL SHAFT with a HAIRPIN CLIP on each
side of the WHEEL. (Refer to Figure 4.1.)
4. Place one end of the WHEEL SHAFT through the
SLOT in the fastened SIDE FRAME.
5. Fasten the other SIDE FRAME to the SUPPORT.
Place the other end of the WHEEL SHAFT in the
SLOT. Line up the holes in the SUPPORT with the
holes in the SIDE FRAME. (Refer to Figure 4.1.)
6. Secure 1 BUTTONHEAD SCREW through each hole.
Keep these BUTTONHEAD SCREWS slightly loose.
7. Place the WEIGHT WHEELS on the CONVEYOR as
shown in Figure 4.2. The TABS at the bottom of each
SIDE FRAME fit over the sides of the CONVEYOR,
and the MAGNETS rest on the CONVEYOR.
8. Make sure the MAGNETS are flat on the
CONVEYOR. Tighten all 4 BUTTONHEAD
SCREWS. (Refer to Figure 4.2.)
9. Position the WHEELS over the TRANSPORT BELTS.
Slide the HAIRPIN CLIPS against the sides of the
WHEELS to hold the WHEELS in place.
Figure 4.2 -- FD 260-20 with Weight Wheels