Formax FD 4400 - Manual (Page 7)

Vacuum Hose
Right blower hose Left blower hose
Fig 4
2. Connect the blower hoses (Fig 4) and feed thru the
holes located on the infeed side of the base (holes
are to the left if you are looking at the operator side of
the burster).
3. Connect the vacuum hose (Fig 4) and feed up
between the infeed of the burster and feed table
support braces on the infeed side of the base (holes
are to the left if you are looking at the operator side of
the burster).
Remove four screws
1. Remove four Phillips head screws from infeed
cover (Fig 5) and tilt cover back.
Fig 5
Air Feed Table Installation
Fig 6
2. Attach vacuum hose to the feed table, then set
table into place (Fig 6).
Metal fi ngers
3. Guide the metal fi ngers under the blind roller and
slide the table into position (Fig 7).
4. Reset the table on infeed cover and align the holes
on the side of the table with the brackets mounted on
the cover (Fig 8).
Brackets Rear cross brace
Fig 7
Fig 8
3
Vacuum V V
hose