Maintenance and inspection – Formax FD 8804 User Manual
Page 11
Emptying the Waste Bin
Shredded paper and particles accumulate in the shredder waste bin during normal operation. When the red
“Waste Bin Full” lamp lights, empty the waste bin.
1. Switch the shredder off by pressing the STOP pad on the control panel, turn the OFF/ON key switch to
the OFF position and flip the main power switch to the OFF position.
2. Turn the door handle to the right and open the waste bin access door. Pull out and empty the waste bin.
3. Push the waste bin back in, close the door, turn power switches back on and resume shredding.
Maintenance and Inspection
8
Conveyor Belt Maintenance
•
Checking Belt Tension
When loaded with material, the conveyor belt must not slip, i.e. stand still when material is loaded. If the
belt slips, it must be tightened. Contact the Formax Service Department for assistance.
•
Checking Belt for Wear
The upper surface of the conveyor belt can become worn over time. The belt must be replaced when
the woven fabric inlay becomes visible. Contact the Formax Service Department for assistance.
•
Cleaning the Conveyor Belt area
The conveyor belt area must be cleaned once a month, or as needed to maintain optimal performance.
1. Switch off the shredder and unplug from wall outlet.
2. Remove the covers on both sides, revealing the cleaning openings in the conveyor belt area.
3. Use compressed air to blow out particles, or a vacuum to remove dirt and dust.
4. Re-install both side covers.
NOTE: Paper clips in the shredded materials may increase the frequency of cleaning necessary, and may
become caught in the sides of the belt.
Removing & Reinstalling Side Covers
Each side cover is attached by four Phillips head screws.
1. To remove a cover, insert screwdriver through access holes (Fig. 4),
and remove screws.
NOTE: It is easier to remove the lower two screws first, then the top
two. When reinstalling the cover, install top screws first, then lower.
Fig. 4
NOTE: The maintenance procedures
which follow should be performed only
by authorized and trained technicians.