Formax FD 342 - Manual (Page 6)

Fig. 1b
Locating Pins
2
Lower Fold Table Pins
Fig. 1a
Locating Pins
Upper Fold Table Pins
UNPACKING & SETUP
1. Check package for shipping damage. If there is shipping damage, do not discard the box.
2. Remove the machine and packed components from the box. The fold plates, telescoping stacker, Optional Multi
Sheet Feeder if ordered, power cord and cross-fold guide are wrapped separately in the box.
NOTE: Two people must lift the machine from the box.
3. Place the folder on a solid stand.
Install upper and lower fold plates, telescoping conveyor
multi-sheet feeder and power cord
1. Be sure the plates are set firmly on the locating pins
(Fig 1a & 1b). Slide each fold plate in until it meets the
first locating pin then push down to set in place.
2. Repeat the same steps for the lower fold plate.
3. Insert the telescoping extension tray into the end of the
outfeed conveyor (Fig. 2).
Fig. 2
Telescoping extension tray