Formax FD 342 - Manual (Page 10)

6
MULTI-SHEET FEEDING (OPTIONAL)
The multi-sheet feeder is designed to fold pre-collated stapled or unstapled sets of up to four 20 # (75gsm)sheets of pa-
per.
1. Adjust the side guides on the milti-sheet feeder for the
proper paper size. Loosen the brass thumb screw, ad-
just the guides to fit the paper width and re-tighten the
thumbscrew (Fig 9a).
2. Slide the pre-collated paper set into the multi-sheet
feeder. When feeding stapled sets the documents
should be placed with the staple on the operator’s side
and leading (Fig 9b).
3. The sheets of paper will be automatically pulled into the
folder (there is a one-second delay after the paper is
placed in the feeder).
4. If the fold is skewed, turn the skew adjustment knob
located on the back of the feeder left or right to make
corrections (Fig 9c).
5. To remove the multi-sheet feeder depress the release
levers located on either side of the lower back side of
the feeder (Fig. 9d), tilt the feeder forward and lift. To
reinstall depress the levers and reinsert.
Staple
Fig. 9b
Fig. 9a
Fig 9c
Brass thumbscrew
Skew Adjuster
Release Levers
Fig. 9d