Formax FD 332 - Manual (Page 19)

19
(5) Trouble Shooting
Trouble Possible Cause Measures
Paper sticks just after it is
printed Jog the paper sufficiently or feed the paper
after it is dry.
Stains on the paper separator
Clean the paper feed separator using
approved cleaner.
Stains on the paper feed rubber
roller. Clean the paper chips or ink on the paper
feed roller with approved cleaner.
The paper separator is worn out.
Replace the paper separator with a new
one.
The paper does
not feed properly
The volume of the paper stacked
on the paper feed table is not
enough.
If the volume on the paper feed table is not
enough, it does not feed since the paper
detection lever is installed.
Stack 20 sheets or more.
The machine does
not operate even
after the Start/Stop
key is pressed.
Paper jam inside the unit.
Detach Table 1 and 2 and remove the paper
in the unit.
Paper sticks just after it is
printed Jog the paper sufficiently or feed the paper
after it is dry.
Stains on the paper separator
Clean the paper separator using the
approved cleaner.
Stains on the paper feed roller
Clean the paper chips or ink on the paper
feed roller with the approved cleaner.
Stains on four paper fold rollers
Clean the stain on four fold rollers using
approved cleaner.
Table 1 and 2 are not properly
set.
Reset properly.
Wrinkles appear on
the paper.
Paper jam in Table 1 and 2
Detach Table 1 and 2 and remove the
jammed paper out.
Improper fold
position
The total length of the paper is not
standard size.
Measure the total length of the paper and adjust
using the fine adjustment knob